How to install water softener drain line

Learn how to connect the drain line to the Fleck. We recommend that the drain hose is kept as short as possible. Tie into sanitary sewer for water softener drain?

This backwashing drain line will be under pressure (your normal household water pressure) when the backwash cycle is working. The drain hose that comes from the water softener needs to terminate in. Run the pipe-work from the bypass to the water softener using WRAS . A softener drain line must not be connected directly to the waste .

The distance between the softener and the drain should be as short as possible. If the softener is being installed in your loft, 1st, 2nd floor etc, it is recom mended. If you are planning to install the water softener above ground level, e. Measure the length between the cold water line and the bypass ports on the water softener tank.

With water softener installation, you must provide drainage. This will help you drain water from the lines and make it easy for you to install the softener system. Installation with water in the reservoir can be . Install an air-gap fitting to the drain that leads to the sewer pipe.

Softener should be as short as possible.

Check Existing Plumbing And Repair Prior to Install Of Water Conditioner. Caution: Before starting system up, check water softener drain line to insure that it . Customer: I need to run it up to the attic and over ~ft then down the wall to an unused . Under sink models can usually drain straight into the waste line. Do not put salt in the brine tank until you have put the softener into service and have tested. In one sentence, the installer directly connected the water softener drain line to the.

At different stages of the regeneration of your softener, water will be sent to drain. So this is garage-related insofar as the water softener is in my. The softener drain line must not be connected directly to the waste system, but . IMPORTANT: Make sure that the softener and pipe. Locate the water softener inside where the temperatures do not drop below freezing. Assemble all tools needed to install the unit.

If so, I would suggest running the drain line for the water softener to . The parts required to assemble and install the water softener are included with the unit. Make the valve drain line as short and. Box contents: 2m Overflow Line Connection Pipe. Jubilee Clips to secure pipes to softener.

The water softener drain pipe is connected directly. The only lines missing from this diagram are, the water softener overflow, and drain . Nearby floor drain or standpipe to connect to the softener for use.